vcimg      View Cart

Items:   0    Total:   $ 0.00

PRODUCTS
How to order

Gullsweep Canvas Pole Mount


GSCP Gullsweep Canvas Pole Mount

$ 19.00
 

Bookmark and Share



Description


Imported and Distributed throughout Australia by Marine Solutions, the innovative Gullsweep® bird scarer is a cost-effective and convenient means of ridding your boat of sea birds and their messy deposits!

The unobtrusive and effective Gullsweep® acts as a deterrent which makes gulls uncomfortable enough to select another roosting site. As birds are always alert to their predators, Gullsweep® creates an unknown fear that the moving object represents a potential danger, and so, unwelcome airborne guests move on to settle (and soil) elsewhere. The unit deters all marine birds, eliminates cleaning time and unsightly stains, and simply makes the boating experience more enjoyable. The Gullsweep® is very easy to install, doesn’t require onboard power, works while you’re away, and folds in half and stows away quickly when you want to get underway.

Fishing/boating/media identity Rex Hunt is one of many satisfied Marine Solutions customers to use Gullsweep®. In the time he has had them installed on his boat he has been more than satisfied with the results. “Gullsweep has reduced my seagull droppings problem by 90%... now combined with artificial snakes on the deck my problem is minimal,” he said.

The Gullsweep® sweeps a full 1.8m (6’) diameter and intimidates birds with each movement. Depending on the size of the vessel, a second or third unit may be required for full boat coverage.

  • Deters all marine birds
  • Eliminates cleaning time and unsightly stains
  • Makes your boating more enjoyable
  • Easy to install (2 screws) or quick non-permanent mountings available
  • Folds in half and stows away quickly
  • Doesn't require any on board power
  • Works while you are away
  • Sweeps a full 6' diameter and intimidates birds with movement
  • You may consider a second or third unit for full boat coverage
  • Do not run boat with Gullsweep in place
  • To stow away, simply fold in half and snap vanes on top of support rods

 

gullsweep canvas pole mount  

Canvas Pole Mount - GS CP -

Canvas Pole Mount is designed to fit the plastic tip of most common Cover Support Poles (Taylor Made, Taco, etc) that pass through a grommet in the cover. It is important that the canvas is taut so the pole does not fall to one side or the other and the wind will not get under the cover. Check to see that the Gullsweep® arms are parallel to the water and that the vanes will not touch the surface (and produce wear to the canvas).
Thread the Center Pin provided with your GS-1 into the threaded end of the GS-CP.
Place the Stainless Steel Washer on the Center Pin, then the O-Ring to keep it in place.
Push the GS-CP Assembly on the Support Pole before the canvas has been installed.

Notes:

If the GS-CP hole is too tight you can cut a slot in the open end with a hack saw. This will allow it to expand slightly. Cut a little at a time until it fits securely.
If the GS-CP is too loose on the support pole, use tape or a rubber band to build up pin dia.
Adjust the pole height to have some tension on the cover. Loose poles may get picked up by the wind and the bottom moved out of position.
Insure adequate clearance between the rotating Gullsweep and the cover to prevent wear or tearing of cover. If necessary, the GS-CP can be put on the Pole after the canvas for more height, or the arms can be bent up and down, level to gain height over the canvas (see GS-1 Instruction Sheet.)


Related Items



#
#
#